Vidikron PlasmaView VP-6000 VHD Owner’s Operating Manual
51
PRE
L
IMINAR
Y
6.1
RS-232 Connection and
Port Configuration
To interface the PlasmaView VHD with a home theater automation/control system or a PC
running terminal emulation software, connect it to the RS-232 output of the VHD Controller
as shown in Figure 3-3. Connect your control system or PC to the RS-232 input of the VHD
Controller as shown in Figure 3-9.
Configure the RS-232 controller or PC serial port as follows: no parity, eight (8) data bits, one
(1) stop bit and no flow control. Set the baud rate to 19200, to match that of the VHD
Controller RS-232 port.
6.2
Serial Command Syntax
Serial commands to the VHD Controller take the following form:
• Commands are not case-sensitive.
• For a single command that takes no parameters, type the command followed by a
carriage return; for example, to set the aspect ratio to Letterbox, type
LETTERBOX
<Enter>
.
• For a single command that takes a parameter, type the command, a space or a comma
and the desired value followed by a carriage return; for example, to set the brightness to
-10, type
BRIGHTNESS
-10
<Enter>
or
BRIGHTNESS
,
-10
<Enter>
.
• You can also send a string of multiple commands on a single line, separated by commas.
For example,
COMPOSITE,BRIGHTNESS 100,ANAMORPHIC
<Enter>
switches to
the Composite video input, sets the brightness to 100 and sets the aspect ratio to
Anamorphic. Command strings can be up to 255 characters long.
6
Serial Communications
Avoid combining the
ON
or
POWER 1
commands with other commands on a
single line. After sending
ON
or
POWER 1,
allow at least five (5) seconds for
the VHD Controller to power up. If you have enabled the ISF splash screen
(refer to “Splash Configure” on page 42), allow 15 seconds for the VHD
Controller to power up.
Once it does, it will accept and properly execute multiple serial commands.
Note
