Videx IP videokit IPVK/6296 Series, Installation Handbook

Page: 27 / 76

66550062-EN - V6.0 - 31/10/21
- 27 -
IPVK/6296 Series IP videokit
IPVK/6296 Series - Installation handbook
VX IP WIZARD
Wizard configuration software for VIDEX IP System
DESCRIPTION
The VX IP WIZARD is a configuration software for the VIDEX IP
System and runs on Windows 7 or higher operating systems.
Install the software then run the “VIDEX IP WIZARD” with admin-
istrator rights ( Fig. 1 ). While the VX IP WIZARD is running, it is
required to create a rule for this software on Windows firewall
(not to disable the firewall).
The system uses a specific network class address, before starting
the configuration it is necessary to change the network card IP
address as described in the ‘preliminary network setup’ section.
For the system configuration it is strongly recommended to use
a PC with two network cards, one connected to the VIDEX IP
SYSTEM and one connected to a network that can access the
web to be able to receive Online support (For example a laptop
with an Ethernet connection and a Wifi connection).
The IP kits are configured to work out of the box. The wizard
may be used to change these default settings.
Fig. 1
VX IP WIZARD
SYSTEM CONFIGURATION
The system configuration consists of
• Device detection & initialisation.
• Outdoor panel settings
• Video intercom settings
• Edit Device Global Parameters
• Edit System Preferences
• Register the installation site on the Videx Cloud for use with the Videx Cloudnected client app
During the system configuration it is strongly recommended to give a descriptive name to each device & relay that will identify the
device location and the relay function i.e.:
• “Main Entrance” can be the device description of the door panel at the front entrance.
• “Pedestrian Gate” can be the description for the relay that enables the pedestrian gate.
• “Vehicle Gate” can be the description for the relay that enables the vehicle gate.
• “Ground Floor” in an apartment system can be the description of the videophone installed on the ground floor.
• “First Floor” in an apartment system can be the description of the videophone installed at the first floor.
These names will be shown during the operation and will make it easier to configure, test and use the system.
It is strongly recommended to do the setup in two steps, first setup all the network and device names and a second step to setup
functionality.
The correct assignment of names to each device and service will simplify the system setup.
Note that according to the installation size and the network traffic of the system to which the devices are connected, may happen that some operations some functions may not be immediate: i.e.
after a firmware update of a device, may be necessary some seconds before the device is recognized again by the Videx IP Wizard, in these cases please repeat the operation.