Videotec sm328a, Operating Instructions Manual, Page: 22 / 344

•
closed periods during the week, extra holidays and periods when the building is closed.
While the parameters are being edited the bottom lines will show the permitted values for the parameters
actually being modified.
3.4.7.1 Weekdays
For each day of the week (Monday, Tuesday etc.) it is possible to define a maximum of four time bands
during which the system is considered
open. At all times outside these 4 periods the system is considered
closed.
It is possible to copy the parameter settings for a particular day using the

key so as to simplify
insertion when the periods are the same (from Monday to Friday for example). To cancel a line press

when inserting the numeric value.
3.4.7.2 Holidays
Holidays are defined as feast days that are not included as normal non-working days (e.g. Sundays).
For each day key in the numerical values as requested. If the value inserted is not valid, the previous
setting will not be changed. To cancel a line press

when inserting a numerical value.
It is possible to define a maximum of 16 individual holidays over the year.
3.4.7.3 Closed Periods
These are periods when the building is closed (for holidays) and are defined by (inclusive) initial and final
dates.
It is possible to define a maximum of 8 closed periods over the year.
3.4.8 Time
For Time it is possible to make the following settings:
•
current time
•
format (24-hour international or 12-hour English with AM/PM)
•
position and display (or not)
•
parameters for automatic management of summer and solar time periods.
3.4.8.1 Summer and solar time
Summer/solar time can be managed in 2 ways:
•
Automatic : a number of parameters should be inserted (Last Sunday in March for example). It is
possible to select pre-set parameters for certain zones by pressing the

key.
Warning! The pre-set parameters are determined by legislation, which may be changed without prior notice.
•
To change the parameters press the corresponding number and select the desired value with

and

; confirm the selection with

.
•
Date/Time : used when the date and time of the start and end of summer time is known.
Warning! The Date/Time type parameters are valid for only one year and should then be reset to the correct values as
and when necessary.
3.4.9 Enabling the keyboards
(Are some of the keyboards enabled only during certain timebands?)
Each keyboard is identified by a number from 1 to 8, which is set at the keyboard level, independently of
the matrix connector to which the keyboard is connected.
•
3. Setup Page 18/66 MNVCSM328A_1511_EN