Backflow Direct Tamper Switch Recommendation
Note:
The weatherproof cover may need to be removed to run leads through the elbow. The cover can be removed by using a Philips
head screw driver to remove the screws located on the cover.
BD-INST-TS | Rev A | 01/10/2017 | Copyright 2011 Backflow Direct, LLC
Install 90 Degree Pull Elbow
A.
If the pull elbow did not come with a threaded end attach a ½” close nipple to the 90 degree pull elbow.
B. run the electrical leads from the gearbox through the 90 degree pull elbow and then attach the 90 degree pull elbow by inserting
the close nipple into the threaded port on the gearbox.
C. If the cover plate was removed reinstall the cover plate and turn the 90 degree pull elbow to a 45 degree angle upwards to allow
room for LB Conduit body installation.
Page 3 of 4
A
B
C
Summary of Contents for VicFlex AH1
