Vicon surveyor X971, Installation And Operation Manual

Page: 43 / 53

Maintenance
The Surveyor Mini Dome requires no scheduled maintenance, however the Domes require occasional
cleaning .
CARE AND CLEANING OF METALLIZED DOMES
1. Always handle the Dome by the flange and avoid touching the inside surface as acid in a fingerprint can
etch the coating. Use the recommended cleaning procedure in Step 4.
2. If dust or dirt accumulate in the dome's interior, it should be removed with clean dry pressurized air.
3. If spots, streaks or stains appear on the inner Dome, they can be removed by rinsing with clean water
and drying with clean, dry pressurized air. Do not rub the inner surface.
CAUTION: Rubbing on the inner Dome surface can cause permanent scratches
4. If wiping is necessary, use a wick. Make a "wick" by rolling a section of soft paper towel into a tightly
wound tube and tear it in half. Moisten the torn edge of the wick with a solution of mild soap and water.
Hold the Dome upside down and gently wipe the surface from the inside to the outer edge. Then, rinse
with clean water and dry with clean, dry pressurized air.
5. Clean the Dome's exterior with any soft cleaning cloth and a mild glass cleaner suitable for acrylic plastic.
CARE AND CLEANING OF CLEAR ACRYLIC DOMES
1. Always handle the Dome by the flange and touching the inside surface.
2. If dust or dirt accumulate in the dome's interior, it should be removed with clean dry pressurized air.
3. If spots, streaks or stains appear on the inner Dome, they can be removed with a solution of mild soap or
isopropyl alcohol and water using a lint-free soft paper towel. Dry with clean, dry pressurized air.
4. Scratches or surface blemishes may be removed with a nonabrasive wax using a soft cleaning cloth
CAUTION: Excessive rubbing of the Dome surface can cause permanent scratches.
5. Clean the Dome's surfaces with any soft cleaning cloth and a mild glass cleaner suitable for acrylic
plastic.
Fuse Replacement
Two fuses (F1 and F2) are located on the Customer Interface Board. When necessary, replace them with the
following fuse value:
2AG, 3.5 amp, 250 volt, slo-blo
X971 Rev 1098 Surveyor Mini Dome System Maintenance
•
29