Vicon surveyor X971, Installation And Operation Manual

Page: 15 / 53

Introduction
The information in this manual covers the installation, configuration and operation of the Surveyor Mini Dome
System. This system should only be installed by a qualified technician using common hand tools and
approved materials in accordance with national, state and local wiring codes.
The basic Surveyor is a compact, intelligent, high-speed Mini Dome. For programming information, refer to
the Surveyor Programming Manual X867, part number 8006-8867-01-00.
Surveyor complies with UL standard 1409, meet requirements for an FCC Class A computing device, and
comply with European Community EMC Directive 89/336. The product was subjected to the testing outlined
in European Normalization Standard EN 50081-1 (Electromagnetic Compatibility-General Emissions
Standard Part 1: Residential, Commercial and Light Industry), and EN 50082-1 (Electromagnetic
Compatibility-General Immunity Standard Part 1: Residential, Commercial, and Light Industry).
Figure 1
Basic Surveyor Unit
NOTE: Read all instructions before beginning any
installation.
NOTE : The following instructions are “typical”. It
may be necessary to deviate from them for
any particular installation.
Unpacking and Inspection
All Vicon equipment is tested and inspected before
leaving the factory. It is the carrier’s responsibility to
deliver the equipment in the same condition as it left
the factory.
Inspection for Visible Damage
Immediately inspect the cartons upon delivery. On all copies of the carrier’s freight bill, make a note of any
visible damage.
Make sure the carrier’s agent (the person making the delivery) signs the note on all copies of the bill. If the
agent does not have claim forms, contact the carrier’s office.
Inspection for Concealed Damage
As soon as possible after delivery, unpack the unit and inspect it for concealed damage. Do not discard the
carton or packing materials. If the unit is damaged, contact the carrier immediately and request forms for
filing a damage claim. Make arrangements for a representative of the carrier to inspect the damaged
equipment.
If the equipment must be returned for repair, follow the Shipping Instructions at the end of this manual.
X971 Rev 1098 Surveyor Mini Dome System Introduction
•
1