Vicon surveyor X971, Installation And Operation Manual

Page: 26 / 53

SOLID CEILING
The Surveyor mounts in a Solid Ceiling cutout and is supported by the Trim Ring. There are four knockout
holes on the Trim Ring which must be removed prior to installation. The installer must supply mounting
screws and verify ceiling strength for this installation.
Figure 13
Exploded View - Solid Ceiling
Figure 14
Cable Access Cap
Installation Into a Solid Ceiling
Before starting, route all cabling from the control
equipment to this location.
The Cable Access Cap is included in the Mounting
Kit and is installed to permit the installation of a strain
relief type or Conduit fitting into it. This cap provides
two different diameter holes; 1.062 inch (2.7 cm) and
0.875 inch (2.2 cm) for a 0.75 inch (1.9 cm) and a 0.5
inch (1.3 cm) standard fitting, respectively. If the
0.75 (1.3 cm) standard fitting is used, simply remove
the knockout.
1. Insert the legs of the cap through the top opening
of the Housing.
2. Fold the two legs over to secure the cap in place.
3. Install the Conduit fitting.
4. Cut a 12-1/8-inch (30.8 cm) diameter hole at the
desired location in the solid ceiling.
5. Remove the four knockouts on the Trim Ring.
6. Stabilize the Housing and position the Trim Ring
over the Housing lower rim. Push up on the Trim
Ring inner edge firmly and, using the other hand,
push down on the Trim Ring outer edge. A single
snapping sound will verify that the latch has been
properly seated. Repeat on the remaining three
latches.
7. Lift the Housing up into the ceiling, through the
previously cut hole, and attach with four screws.
12
•
Housing Installation X971 Rev 1098 Surveyor Mini Dome System