Vicon surveyor X971, Installation And Operation Manual

Page: 37 / 53

Disassembling the Mini Dome
The Mini Dome can be easily disassembled by simply removing the domes and Drive Mechanism. The
Housing and cabling remains intact during disassembly. It is not necessary to disable the 24 VAC power.
Perform Step 1 for a particular installation type and continue with the remaining steps for all installation types.
1.
For Indoor Pendant and Dropped and Solid Ceiling Installations:
Gently pull down the Lower Dome outside edge, with two hands, until all metal clips snap out of place.
1. For Outdoor Pendant Installations:
Remove the four screws from the Outdoor Lower Dome and lower. Use tamperproof key, if necessary.
2. Verify that the Green LED is not illuminated. If it is, place the RUN/SERVICE switch to the RUN position.
Gently pull the Mask down until the magnetic latches snap out of place. The Red LED should illuminate.
CAUTION: Failure to verify illumination of the Red LED and position of the RUN/SERVICE switch prior to
removal of the Mask can cause injury to the technician and damage to the unit.
Figure 26
Drive Release Handle
3. Disconnect the spring clip on the
end of the Lanyard from the
mating latch on the inside of the
Drive.
4. Slowly rotate the Drive until the
arrow on the Drive lower rim
aligns with the arrow on the
Housing inside edge. Verify that
the Drive Release Handle is
visible through the slot behind
the Camera/Lens Module.
5. Support the Drive with one hand
and insert the supplied Removal
Tool into the slot as shown in
Figure 26, “A”.
6. Latch the Removal Tool onto the
Drive Release Handle and pull
downward until the spring
latches disengage as shown in
Figure 26, “B”. The Drive will
release.
7. Carefully lower the Drive while
releasing the Drive Release
Handle.
X971 Rev 1098 Surveyor Mini Dome System Disassembling the Mini Dome
•
23