Vicon RF121 R, Operation Manual

Page: 56 / 61

54
EN
16657715_en 05/2006
7 Accessories
7.1 Central chain lubrication device
To reduce the amount of maintenance needed for the
drive chains, an automatic chain central lubrication
device is provided as optional equipment. The oil level
in the lubricant container is to be checked daily. If
necessary, the adhesive oil for the chain (biological
chain oil) should be topped up.
The distribution pump is connected to the tailgate
hydraulic system and is activated by the pressure pulse
when opening the tailgate. A given amount of lubricant
is pumped from the oil container into the supply pipes
and applied to the chains using brushes. The brushes
should be adjusted so that they are just touching the
chains.
7.2 Filler plates (125 OC14)
When the cutting device is not mounted or if the cutting
system is being used with less than 10/14 blades, the
slits in the floor of the cutting unit are to be closed using
filler plates. The filler plates keep the blade slits clean
and ensure that the flow of material around the floor of
the cutting unit remains even.
7.3 Bale ramp
When using the bale ramp, the bales are deposited
gently onto the ground and roll out of the tailgate area
so that, under normal working conditions, it is not
necessary to drive forward again to close the tailgate.
Attention!
Only open the tailgate when the machine
is running to make sure that the bale is
ejected. On sloping ground, the bales
should be deposited face down on the
slope. There is a risk of injury if the bales
roll away.
7.4 Additional twine / net boxes
If only one tying system is installed, the twine or net
capacity can be increased by installing additional spare
boxes: the twine box of the twine binding unit can be
used for the stowage of a second net roll and in the
net box of the net wrapping system can be installed 4/
6 further twine spools.