Vicon RF121 R, Operation Manual

Page: 44 / 61

42
EN
16657715_en 05/2006
5.4.3 Adjusting the cutting angle
Blade shaft, pos. 1
- steep cutting angle for ‘precision cutting’
Blade shaft, pos. 2
- obtuse cutting angle for ‘normal cutting’
(approx. 20% lower power consumption)
Adjusting the cutting angle from ‘normal cutting’ to
‘precision cutting’:
Move out the cutting system hydraulically, switch
off the tractor engine
Unscrew fixing bolt M10 (a) on the left and
right-hand sides,
Undo the hinge screw M10 (b) on the left and
right-hand sides,
Move in the cutting system hydraulically, switch
off the tractor engine,
Assemble fixing screws (a) in the upper position,
Tighten the fixing and hinge screws (a, b) at the
left and right.
Adjusting the cutting angle from ‘precision cutting’ to
‘normal cutting’:
Move in the cutting system hydraulically, switch
off the tractor engine,
Unscrew fixing bolt M10 (a) on the left and right-
hand sides,
Undo the hinge screw M10 (b) on the left and
right-hand sides,
Move out the cutting system hydraulically, switch
off the tractor engine,
Assemble fixing screws (a) in the lower position,
Tighten the fixing and hinge screws (a, b) on the
left and right-hand sides.