Vicon Extra 532, Service Manual, Page: 66 / 90

Assembly of cutter bar
Assembly of cutter bar
Assembly of cutter bar
Assembly of cutter bar
Assembly of cutter bar
Assembly of cutter bar
Removing cutter bar out of unit
Removing cutter bar out of
unit
• Torques for the bolts holding
the bracket on the frame;
81Nm. (60 ft/lb). • Torques for the bolts holding
the stone guards; 47Nm. (35
ft/lb)
• Remove the stone guard on
the LH side.
• Remove the 5 bolts on the LH
side
• Move cutter bar just far
enough sideways to get the
conus out of the conical hole
in the LH support bar on the
LH side by using a crowfoot.
• Lift the cutting unit or lower
the cutter bar in case it’s lying
on the forks of a fork-truck.
X
Y
• For assembly it’s the other way
around.
• Torques; on each side of the
cutter bar;
X 130 Nm (96 ft/lb)
+ Lock tide 241
Y 85 Nm (63 ft/lb)
NB!
For these 5 bolts on each
side, always use the Nord-Lock
washers
!
Use the wide ribs on the inside as
shown on the picture!
4.8.1 Cutter bar-repair instructions
66