Vicon Extra 532, Service Manual, Page: 37 / 90

Changing of lifting cylinder(s) Changing of lifting cylinder(s) Changing of lifting cylinder(s)
Changing of lifting cylinder(s)
Changing of lifting cylinder(s)
• Tighten the springs on both
sides of the machine to the
required setting.
• Tighten and secure the
counter nut as shown.
Note;
with a lifted cutting unit job
goes easier.
• Attach the hydraulic system of
the machine to the tractor and
keep the unit on the ground.
• Activate the hydraulic system of
the tractor in such a way that you
extend both cylinders completely,
be aware that this can take approx.
2-5 minutes.That insures the
machine's hydraulic cylinders is
filled with hydraulic oil.
• After that, carefully raise the
cutting unit and check that the
cutting unit is parallel to the main
frame of the machine.
• If not parallel- lower the cutting unit
down again and repeat the
procedure.
Changing of lifting cylinder(s)
4.3 Replacement lifting cylinders
37