Seeker HL User’s Guide
Document Num., Rev. 2
May 2018
Page 34
Display Messages & Error Codes
Seeker HL Error Codes
The codes shown below are displayed on the Seeker HL display
screen as “E##” to indicate errors.
“E##”
Code
Error Description
Solution
01
The checksum is not valid for this area
or the calibration date for this area is
not set.
If a power cycle does not fix this,
return to the factory for recalibration.
02
The checksum is not valid for this area
or the calibration date for this area is
not set.
If a power cycle does not fix this,
return to the factory for recalibration.
08
The flash ID read did not correspond
to approved devices.
If a power cycle does not fix this,
return to the factory for repair.
17
Error in stored unit serial number.
If a power cycle does not fix this,
return to the factory for repair.