Seeker HL User’s Guide
Document Num., Rev. 2
May 2018
Page 26
• Use the
SELECT
button to toggle
through its display modes. As you
toggle, the display modes will
appear in the same order in which
they are discussed in this section.
• Use the
CHANGE
button to adjust
the settings of some display
modes.
Device Information & Settings
While testing for leaks, you will need to view the information shown by the Seeker’s display
modes.
Viewing the Battery Charge
Level
To check the battery level, turn your Seeker HL on and press the
SELECT
button (middle
right) once.
If the “Enable Meter Entry” checkbox is checked within the Seeker Setup software during
configuration, you will need to press the
SELECT
button (middle right) six times to view the
battery level.
• When the Battery Charge Level display is selected, the
Battery icon flashes.
• The bar graph will indicate the amount of battery charge
available. As long as there are at least a few bars left, your
Seeker HL has enough charge to operate. If the battery
meter shows less than 50%, the Seeker HL should be
charged.
The display will revert to the Signal Level display after a few
seconds in the Battery Charge Level display (without any
action by the user).
Battery Charge Level