Seeker HL User’s Guide
Document Num., Rev. 2
May 2018
Page 28
Ambient Noise Level Measurement
This measurement is used to find ambient noise sources that may be emmiting RF signals
at the currently selected leakage frequency. This provides a useful tool for troubleshooting
noise issues that may occur in and around the house.
The image to the right shows the noise setting screen which
allows the operator to toggle the tag icon off temporarily to show
ambient noise. Press the
SELECT
button (middle right) two times
to view the show noise setting.
• When the Tag icon is selected, pressing the
CHANGE
button will enable/disable the Ambient Noise Level
Measurement function.
• When this display is selected, the following will occur:
• If the Ambient Noise Level Measurement function is currently disabled, only
the arrow below the Tag icon will flash, as shown in the image above.
• If the Ambient Noise Level Measurement function is currently enabled, the
Tag icon will flash a few times prior to turning off (with the arrow below the
icon).
• When the Ambient Noise Level Measurement function is enabled, the following will
occur in the Signal Level display:
After a few seconds in the Ambient Noise Level Measurement
display without any action by the user, the display will revert
to the Signal Level display.
Ambient Level
Measurement Enabled