Seeker HL User’s Guide
Document Num., Rev. 2
May 2018
Page 30
Speaker Volume Level
While testing for leaks, you may need to adjust the volume of the leakage tone.
After a few seconds in the Speaker Volume Level display
without any action by the user, the display will revert to the
Signal Level display.
The speaker volume does not change during adjustment, but
is instead indicated by the bar graph. When leaks are found,
you will hear the volume change in the leakage tone.
• Use the
VOLUME
button to
adjust the speaker volume.
The bar graph will indicate the
speaker volume level as shown
in the image to the right.
Adjusting the Speaker Volume
To check the volume level, turn your Seeker HL
on and press the
VOLUME
button once.
• When the Speaker Volume Level
display is selected, the Speaker icon is
continuously displayed as indicated in
the following image.
• When this display is selected, the following will occur:
1. The bar graph will indicate the speaker volume.
2. The numerical display will continue to display the RF
signal level.
• Press the
VOLUME
button again to increase the speaker
volume of the leakage tone. Brief presses increase the volume
to maximum and then it rolls over to the minimum volume.
Speaker Volume
1
2