ViaSat Series 8345, Installation Manual

Page: 37 / 76

Chapter 2 - Installation
b. If the holes are not aligned laterally, the bolt at connection "B" must be
loosened just enough to move the Rib and align the holes. After moving the
Rib, retighten the bolt.
PINS
ALIGN RIB HOLE
TEMPLATE
SCREW "B"
NSG 1436A
Figure 2-8. Template Installation
c. With the Rib and template holes aligned laterally, inspect the longitudinal
alignment. If they are not aligned, push the rib to the left or right to slightly
bend it at the location shown in Figure 2-9. This will lengthen or shorten the
rib, allowing alignment of the rib and template holes longitudinally, but it
will cause a lateral misalignment of the holes.
Repeat STEPs 5b and 5c until the holes in the template and Rib are aligned
exactly, and the tapered pins will insert partially into both parts.
42S199F
2-27