54
Using your Viasat box
5. Highlight ‘High Band LO Frequency (GHz)’, then use the
number
buttons to enter
the appropriate frequency. If the number is below 10.000, add a leading zero (for
example, 09.750).
6. Highlight ‘LNB is powered by STB’, then press
L
or
R
to select either ‘ON’ or ‘OFF’.
The default setting is ‘On’.
7. If you selected ‘2 LNBs’ in step 2, highlight ‘DiSEqC port A is connected to’ then press
L
or
R
to select the correct satellite for the LNB connected to DiSEqC™ port A,
either Sirius or Thor.*
8. ‘DiSEqC port B is connected to’ is set to whichever satellite was not selected in step
7
9. To save your changes, highlight ‘Save New Settings’ then press
OK
, or to cancel, press
BACK
.
10. If you have changed your LNB setup configuration you must then check the signal
quality (see page 52).
You can press the
red
button to reset all settings on the LNB setup menu to their factory
defaults. The default values are shown on the image above.
To change the LNB Setup (for SatCR LNBs)
1. On the Installation Setup menu, highlight ‘LNB Setup’, then press
OK
The LNB Setup menu displays:
2. Highlight ‘LNB Type’, then press
L
or
R
to select ‘SatCR’.
3. Highlight ‘Number of LNBs’, then press
L
or
R
to select ‘Single’ or ‘Monoblock’.
Refer to information supplied with your LNB to determine the correct type.
4. Highlight ‘Input 1’, then press
L
or
R
to select ‘UB 1’ – ‘UB 4’.
5. Highlight ‘Input 2’, then press
L
or
R
to select ‘UB 1’ – ‘UB 4’.
These are the numbers (1 to 4) that will be allocated to your box. For full
functionality, it is important that each box in a SatCR installation has two unique
numbers, to avoid conflicting with other installed boxes.
To enable up to 4 boxes to be installed, you can allocate just one number for each
box. However you will not be able to watch one program while recording another.
6. To save your changes, highlight ‘Save New Settings’ then press
OK
, or to cancel, press
BACK
.
For recommended SatCR LNBs, the default User Band (UB) frequency values are
Setup
