55
ENGLISH
already entered; under normal circumstances you do not need to change these. Refer to
information supplied with your LNB. Check that the UB frequencies match those shown in
the Set Frequency menu below. If they do not, you must edit the SatCR UB frequencies.
To edit SatCR UB frequencies
1. Refer to information supplied with your LNB to determine the frequencies required
for each UB.
2. From the LNB Setup menu, press the
green
button (‘Edit UB’).
The Set Frequency menu displays:
3. Highlight ‘UB1’, then use the
number
buttons to enter the required frequency.
4. Repeat step 3 for ‘UB2’, UB3’, and ‘UB4’.
5. To save your changes, highlight ‘Save New Settings’ then press
OK
, or to cancel, press
BACK
.
Setting the Default Transponder
Default values (shown on the image on page 54) are already entered for this setting;
under normal circumstances you do not need to change these. If you change your satellite
dish installation, you may need to change this setting so that your box can tune to all the
satellites available.
To change the Default Transponder settings:
1. On the Installation Setup menu, highlight ‘Default Transponder’, then press OK.The
Default Transponder menu displays:
V
2. Highlight ‘Frequency (GHz)’, then use the
number
buttons to enter the appropriate
frequency.
Setup