3022CS AUTOMATIC UNIT
21
8.6.4.CONTROL OF THE AUTOMATIC SPEED OUTPUTS AND MOTOR STOP
with the arrow down place the flashing cursor beside the Speed Test
The display changes as follows:
Confirm with the key
ENT
The display changes as follows:
In order to check the working remember that the outputs have the following setup:
ATTENTION:
Before passing to the successive control put at zero the one in execution.
-
In the position 1 the input relative to the AUTOMATIC SPEED 1 (SPEED1) function is visualized
Press the key
1
to enable / disenable the function.
The value is 1 (on) when the function is enabled while the value is 0 (off) when it is disenabled.
-
In the position 2 the input relative to the function AUTOMATIC SPEED 2 (SPEED2) is visualized.
Press the key 2
to enable / disenable the function.
The value is 1 (on) when the function is enabled while the value is 0 (off) when it is disenabled.
-
In the position
3
the input relative to the function AUTOMATIC SPEED 3 (SPEED3) is visualized.
Press the key
3
to enable / disenable the function.
The value is 1 (on) when the function is enabled while the value is 0 (off) when it is disenabled.
-
In the position 4 the input relative to the function MACHINE STOP is visualized.
Press the key
4
to enable / disenable the function.
The value is 1 (on) when the function is enabled while the value is 0 (off) when it is disenabled.
To exit the function and return to the principal Menu press the key
ENT
8.6.4.1. LIST OF THE AUTOMATIC SPEED USED
The automatic speed are of different types and they can be recalled through parameters inside the motor panel during
the sewing. Here is the list with the features of every single speed.
SPEED 0
= The machine starts rotating, between zero and the maximum speed settled through the parameter
H, only if the control pedal in the box
is set in any position different from 0 (zero).
SPEED 1
= The machine starts rotating to the constant maximum speed set through the parameter L,
only if the control pedal in the box
is set in any position different from 0 (zero).
SPEED 2
= The machine starts rotating to the constant maximum speed set through the parameter M,
only if the control pedal in the box is set in any position different from 0 (zero).
SPEED 3
= The machine starts rotating, between zero and the maximum speed settled through the parameter V
even if the control pedal is the in the position 0 (zero).
To exit the function and return to the principal Menu press the key
ENT
8.6.5.EXIT THE TEST FUNCTION
With the arrow down, place the flashing cursor beside the Test end.
The display changes as follows:
Confirm with the key
ENT
On the display appears:
LS01
MITSUBISHI GMFY
test Outs
test Speed
Outs Speed
1 2 3 4
Outputs
0 0 0 0 0
test Speed
test End
VI.BE.MAC. 3022
1, PROGRAM 3
Summary of Contents for 3022 Series
Page 60: ...3022CS AUTOMATIC UNIT 60...
Page 61: ...3022CS AUTOMATIC UNIT 61...