3022CS AUTOMATIC UNIT
6
3. DESCRIPTION OF SWITCHES, BUTTONS AND CONTROLS
In the 3022CS unit are the following switches:
3.1 GENERAL SWITCH OF THE MACHINE
It is placed under the table fixed to the pillar of the support.
There are two switches:
The RED one on the left side (OFF) is used to take off current to the unit.
The BLACK one on the right side (ON) is used to supply current to the unit.
3.2 LS01/M GENERAL PANEL SWITCH
It is placed on the frontal of the panel, check the position in the drawing
at the paragraph 7 :LS01/M GENERAL PANEL SWITCH.
The panel automatically switches on when the unit switches on and
on the display the inscription VIBEMAC 3022 and the program in use appears.
3.3 CONTROL BOARD
it is placed at the base of the support, connected through a rod
and a lever to the MITSUBISHI panel. Is used to check the
running of the Automatic Unit.
At the ignition is in neutral position,
Shifting towards down - on the grounds of the executed shifting
the sewing speed changes between the minimum level L and the
maximum H fixed in the software.
Shifting towards up – on the grounds of the executed shifting
there are two available contacts or positions
that recall or
executes precise functions programmed inside the software.
3.4 GENERAL AIR COCK
Placed at the input of the reduction group, allows to take off the air from the
pneumatic circuit inside the machine.
Shift the black selector to choose the two running positions.
To turn the air cock on, move it towards the reducer.
To turn the air cock off, move it towards the outside.
3.5 LIFT PULLER COCK
Placed in the higher part of the cylinder, allows to take off the air
at the inside.
Shift the black selector to choose the two running positions.
To turn the air cock on, move it towards right.
To turn the air cock off, move it towards left
4.
HOW TO START UP THE MACHINE
Press the black button "ON" on the general switch.
The sewing head is ready to work in AUTOMATIC mode with the last program used.
Turn the air cock on, placed on the side of the
reduction group, moving it towards the reducer.
5. HOW TO STOP THE MACHINE
Press the red button "OFF" on the general switch when the machine is stopped.
Turn the air cock off, placed on the side of the
reduction group, move it towards the outside.
6. DIRECTION OF ROTATION
In the 3022 unit a single-phase MITSUBISHI servomotor is used.
Usually, the direction of rotation for the unit considered has already been programmed inside the motor panel.
sewing
the more it moves
the more the
sewing speed
Neutral position
Position I
Position II
Summary of Contents for 3022 Series
Page 60: ...3022CS AUTOMATIC UNIT 60...
Page 61: ...3022CS AUTOMATIC UNIT 61...
