VETRON 5300, Instruction Book

Page: 58 / 83

ESC
000
S E T
30% P
T
1 2 3 4
5 6 7 8 9
10
A B
56 57
07/2020
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
07/2020
VETRON 5300 - POST BED MACHINE - INSTRUCTION BOOK
seam situation
inside seam seam end
P001
P002
end
seam situation
stitch count
» CHAIN PROGRAM
switch over
stitch counted pedal -2 key wheel key
05. PROGRAMMING
05. CREATE PROGRAM CHAIN
-1-4
DISPLAY STEP DESCRIPTION
» CREATE PROGRAM CHAIN
1
Press the CHAIN PROGRAM Key
( 7 )
►
2
S - H ) 0 0 P C - 1 1 0
P m o n r e g a
A sequence of progams will be shown
on the display.
3
►
Turn the JOG KEY
( 10 )
to the right to select the 1
st
program.
4
►
Turn the JOG KEY
( 10 )
to store.
5
S T C D U T E O N
S t i p c w y t e h
You can chose on the display the way
to switch over to the next program.
The following selection of switch over are available (see next page below point 6):
Stitch count = A certain amount of stitches for the seam sequence will be entered (e.g. 30 stitches).
The machine stop after this work step is done. Bring the foot pedal in the centre position to switch to
the next seam sequence.
PEDAL -2 = The seam sequence is done manually. By bringing the foot pedal in position –2 at
the end of the seam the sequence is ended and switches to the next work step. This can be done
with thread trimming or “continue sewing” depending on the program.
Program Key = The next work step is initiated by pressing the key
3
. (see next page)
Electronic handwheel = The next work step is initiated by pressing the electronic handwheel
1
. (see next page)
INFO!
A chain program consist of several programs which a run one after the other. The switch to the next work step can be
chosen differently. It can be done e.g. after a stitch counted seam or by pressing a key. The next step can also be initiated by
the thread cut or the PEDAL -2 position. A chain program will be shown by a diode above the chain program key.