VESPA GTS Supertech 300 hpe, Manual

Page: 52 / 128

INTERMEDIATE PHASE
After having removed the " MASTER " key, insert the secondary key to be programmed
within 10 seconds, and immediately turn it to the " ON " position. Leave the key in this
position for 1 to 3 seconds, then turn it to the " CLOSE " position and remove it. In this
way you can program up to 3 keys, by repeating the above operation and respecting
the indicated times.
FINAL PHASE
After having removed the key to be programmed, insert the " MASTER " key again and
turn it to the " ON " position (this operation must be completed within 10 seconds of
removing the previous key). Leave the key in this position for 1 to 3 seconds, then
return it to the "
CLOSE " position and remove the key.
01_73
CORRECT PROGRAMMING CHECK PHASE
Insert the " MASTER " key, deactivating the transponder " C " (by tipping the key cap
90°), and turn the key to the " ON " position. Perform the engine starter operation. En-
sure that the engine does not start. Insert a programmed key and repeat the start
manoeuvre. Check that motor starts.
WARNING
SHOULD YOU START THE ENGINE WITH THE MASTER KEY (WITH TRANS-
PONDER OFF) OR IN THE EVENT OF WRONG OPERATION DURING PROGRAM-
MING, REPEAT THE PROCEDURE FROM THE BEGINNING.
52
1 Vehicle