VESPA GTS Supertech 300 hpe, Manual

Page: 53 / 128

01_74
Saddle opening remote control (01_74)
The vehicle is equipped with a remote control to open the saddle and for the recog-
nition of the vehicle itself.
This remote control is supplied together with the keys and it has been programmed to
control the opening device control unit at the manufacturing stage. If the remote control
is lost, a new one can be requested and programmed.
•
By pressing the buttons « 1 » or « 2 » of the remote control for about 3 seconds,
the «Bike Finder» device will allow the opening at a distance of the saddle
and the recognition of the vehicle with an optical signal by flashing the turn
indicator. While holding one of the two buttons, the system will continue to
repeat the operation described above until the button is released.
•
By instead pressing the buttons « 3 » or « 4 » of the remote control, the «Bike
Finder» device will be only activated for the recognition of the vehicle by
emitting quick optical signals through the turn indicator.
The remote control is powered by internal batteries that get discharged after extended
used; If the LED turns on when the button is pressed, the remote control is working
properly.
You may need to replace the batteries if the remote control fails or if its range of
operation is reduced. To separate the two halves of the remote control, insert the blade
of a plain slot screwdriver at one point on the edge and slide it all around.
Once the remote control is open, remove the two batteries from the contact terminal.
Install the two new
CR2016 batteries with the positive pole facing the contact terminal.
Reassemble the remote control by pressing the two clip-on halves gently with your
fingers.
53
1 Vehicle