Vertical SUMMIT IP
Hardware Description and Installation Manual
Issue 1.2
74
Figure 7.3.4-2 LIP-8000 series Console Configurations
Referring to Figure 7.3.4-3 below use the following instructions to install and wire the LIP
Console to the associated LIP Phone.
1. Turn the LIP phone and Console upside down
2. Remove the rubber plug in the LIP phone protecting the Console serial cable
connector.
3. Insert the flat ribbon cable from the Console into the connector in the LIP phone.
4. Insert and tighten two (2) screws through the DSS Console mounting flange into the
LIP phone. Caution, do not over-tighten the screws as this may damage the LIP
phone housing.
5. For additional Consoles, repeat the procedure connecting one console to the
previous console.
6. For each LIP-8048DSS and LIP-8040LSS, insert the DC plug of an AC Adaptor-K to
the DC input of the Console and plug the AC plug into an appropriate (110/240 VAC)
outlet.
