Vertical SBX IP 320, Installation Manual

Page: 75 / 148

Basic Programming 6
-
7
Chapter 6: Starting the SBX IP 320
SBX IP 320 Installation Guide
Board Assignment (PGM 101)
To use a CO line, an extension line, and a board, ensure that the code of these boards are
registered on the system at PGM101
When registering a board, if the 4th pole (SW1) of the MBU is on, the board is automatically
registered. While using the SBX IP 320 System, in case of adding some boards, if passively
assigning those, you can use them. When the 4th pole (SW1) of the MBU is on and board is
automatically registered, you must place the 4th pole (SW1) of the MBU off and perform a
system reset.
While in the Admin programming mode,
1. Press the [TRANS/PGM] PGM number (101).
2. Enter slot number (2 digits).
3. Press [FLEX1] button.
4. Enter Board Type code (2 digits).
5. Press the [HOLD/SAVE] button to accept the change.
Table 6-1
Board ID
STA CODE COL CODE ETC CODE
HYBRID 17 VOIB 41 VMIU 64
Table 6-2
Slot Definition
SLOT NUMBER SLOT POSITION KINDS OF BOARDS
01 Hybrid on BKSU HYBRID
02 Optional extension board on BKSU HYBRID
03 Hybrid port on EKSU HYBRID
04 Optional extension board on EKSU HYBRID
05 LCOB on BKSU --
06 Currently not used N/A
07 LCOB on EKSU --
08 Optional LCOB on EKSU --
09 VMIB on BKSU VMIB
10 VOIB on BKSU VOIB