Vertical SBX IP 320, Installation Manual

Page: 123 / 148

[Commands] Menu 9
-
23
Chapter 9: Remote Diagnostics
SBX IP 320 Installation Guide
Using [Input Box Bar]
The [Input Box Bar] can be used to execute almost all the monitoring and diagnostic commands
supported by the SBX IP 320 system. Command usages and limitations follow the SBX IP 320
system specification. The length of input in [SBX IP 320 Command Edit Box] is limited to 40
characters
The [Input Box Bar] can be docked on the top or bottom side of the window.
Procedures for Using [SBX IP 320 Command Edit Box] and [Enter] Button
1. Click on [SBX IP 320 Command Edit Box] so that the input cursor is blinking inside the
box. If the input cursor already exists in [SBX IP 320 Command Edit Box], this
procedure is not needed.
2. Input the SBX IP 320 command in the [SBX IP 320 Command Edit Box]. The length of
the input is limited to 40 characters.
3. Click the [Enter] button to send the command input in [SBX IP 320 Command Edit Box]
to the SBX IP 320 system. Or, you can press the [Enter Key] on the keyboard to send the
command.
• If the [Enter] button is clicked when [SBX IP 320 Command Edit Box] is empty, a
character that corresponds to the [Enter Key] is sent to the SBX IP 320 system.
The same operation can be done by pressing the [Enter Key] when the input
cursor exists in [SBX IP 320 Command Edit Box].
• If you want to log-in again to the SBX IP 320 system after log-out from
maintenance or monitor mode, you can click the [Enter] button to get a chance to
input password and log-in again.
• When you try to execute a remote command (r-type command) that needs an
argument by typing the command in [SBX IP 320 Command Edit Box], you
should also type the argument with the command. For [SBX IP 320 Command
Edit Box], [Enter Command Argument Dialog] is not provided.