Vertical SBX IP 320, Installation Manual

Page: 72 / 148

Basic Programming 6
-
4
Chapter 6: Starting the SBX IP 320
SBX IP 320 Installation Guide
Entering the Programming Mode
To enter programming mode, perform the following Steps:
1. Lift the Handset or press the speaker button on the Admin station. ICM dial tone will
sound.
2. Press the [TRANS/PGM] button and dial * #. A confirmation tone will sound.
3. Enter the Admin password, if a password has been set; a confirmation tone sounds
indicating that the Station is in Admin Programming mode.
4. Each program is accessed by pressing the [TRANS/PGM] button The following will
initially display:
5. Dial the desired three-digit program number. If an error is made while entering data, the
[TRANS/PGM] button will return to the previous status.
Note:
To return to the previous state while in Admin Programming, press the [BACK] soft
button (clears the temporary data fields).
Permanent Update Procedure
To accept changes while programming, perform the following steps:
1. Press the [HOLD/SAVE] button when all changes have been entered to store the data
permanently.
2. A confirmation tone should be heard when pressing the [HOLD/SAVE] button if all data
was entered correctly. If there were any errors in the entering of data, an error tone will be
presented and data will not be stored in the permanent memory.
Resetting the System
To reset the System, perform the following:
Enter [PGM] + 450 then [FLEX] +15 and press the [HOLD/SAVE] button.
E N T E R P G M N U M B E R