FCC ID: K66VX-7R
Operating Manual
Vertex Standard Co., Ltd.
26
3.
Press the [MON/F] key, then press the [0(SET)] key to enter the Set mode.
4.
Rotate the DIAL to select Menu Item (TSQ/DCS/DTMF #5: BELL).
5.
Press the [MAIN] or [SUB] key to set the desired number of rings of the Bell. The
available choices are 1, 3, 5, or 8 rings, REPEAT (continuous ringing), or OFF.
6.
Press the PTT key momentarily to save the new setting and exit to normal
operation.
When a station calls you whose transceiver is sending a CTCSS tone or DCS code which
matches that set into your Decoder, the Bell will ring in accordance to this
programming.
Split Tone Operation
Split Tone Operation
Split Tone Operation
Split Tone Operation
The VX-7R can be operate Split Tone operation via Set mode.
1.
Press the [MON/F] key, then press the [0(SET)] key to enter the Set mode.
2.
Rotate the DIAL to select Menu Item (TSQ/DCS/DTMF #6: SPLIT TONE).
3.
Press the [MAIN] or [SUB] key to set the desired number of rings of the Bell.
4.
Press the PTT key momentarily to save the new setting and exit to normal
operation.
When the Split Tone feature is activated, you can see the following additional
parameters after the “DCS” parameter while selecting the Menu Item (TSQ/DCS/DTMF
#6: SQL TYPE),:
D CODE:
DSC Encode only (“D” icon will appear while operating)
TONE DC: Encode the CTCSS Tone and Decode the DCS code
(“T
∙
D” icon will appear while operating)
DC TONE: Encode the DCS code and Decode the CTCSS Tone
(“D
∙
T” icon will appear while operating)
Select the desired operating mode above.
Tone Calling (1750 Hz)
Tone Calling (1750 Hz)
Tone Calling (1750 Hz)
Tone Calling (1750 Hz)
If the repeaters in your country require a 1750-Hz burst tone for access (typically in
Europe), you can set the MONI key to serve as a “Tone Call” switch instead. To change
the configuration of this switch, we again use the Menu to help us.
1.
Press the [MON/F] key, then press the [0(SET)] key to enter the Set mode.
2.
Rotate the DIAL to select Menu Item (Misc Setup #3 MON/T-CAL).
3.
Press the [MAIN] or [SUB] key to select “T-CALL” on the display.
4.
Press the PTT key to save the new setting and exit to normal operation.
