STEP 15:
Cement the mating surfaces on the reverse side of the left
air/wear plate as indicated in Figure C-9. Insert the front mating
surface of the left air/wear plate against the left end of the front
air manifold and the front of the left stove end at a 30 degree
angle. Holding the wear plate as close to the stove top as
possible, swing the back of the wear plate against its mating
surface (back of the left stove end). Tap into proper position with
the rubber mallet so that the top and bottom drillings in the wear
plate align with the tapped holes in the stove end. Secure with 2
each, hex head cap screws (¼-20 x 1”).
Fig. C-9
Left Air/Wear Plate
STEP 16:
Cement the mating surfaces on the reverse side
of the right air/wear plate as indicated in Figure
C-10. Place the right air/wear plate inside the
stove in an upright position. Thread the primary
air system cable through the hole in the centre of
the thermostat pocket of the wear plate (see
Figure A-3). Insert the front mating surface of
the right air/wear plate against the right stove
end at a 30 degree angle. Holding the wear plate
as close to the stove top as possible, swing the
back of the wear plate against its mating surface
(back of the right stove end). Tap into proper
position with the rubber mallet so that the top
and bottom drillings in the wear plate align with
the tapped holes in the right stove end. Secure
with 2 each, hex head cap screws (¼-20x1”).
Fig. C-10
Right Air/
Wear Plate
Fig. A-3
Right Air/Wear Plate
Ready to be Installed
STEP 17:
Insert the right and left heat deflectors in the right and left
bottom corners of the stove back. Cut 4 each, 5” strips of
¾” square kaowool. Place 2 each kaowool strips side by
side between the left and right pair of ribs in the bottom of
the stove back (see Fig.A-4).
Fig. A-4
Kaowool & Heat Deflector Placement
