Disassembly
STEP 1:
Lift out the griddle. Remove the ash pan and dump ashes in a safe
container outdoors. Wash the ash pan and dry it. The ash pan will make a
good container for screws, bolts, nuts, washers and small hardware items
during the disassembly of the stove.
STEP 2:
Remove the right and left door assemblies. Raise the door until the lower
hinge pin clears its drilling, angle the door bottom slightly outward and
pull down, releasing the upper hinge pin from its drilling.
STEP 3:
Remove the damper handle stub with the 5/32” Allen wrench.
STEP 4:
Remove the thermostat handle with the 1/8” Allen wrench.
STEP 5:
Remove the flue collar, 2 each, Phillips round head machine screws, ¼-
20x1”.
STEP 6:
Remove the top, 2 each, ¼-20 x ¾” hex head cap screws and 4 each, ¼”
flat washers, right and left inside rear and 1 each, ¼-20 x 3/4” Phillips flat
head machine screw, centre front under the griddle handle indent. Strike
the top upward with the rubber mallet to loosen the cement and remove.
STEP 7:
Remove the primary air thermostat access cup, 2 each, ¼-20x1/2” hex
head cap screws. Use the cold chisel in the cement seam.
STEP 8:
Remove the damper link access panel, 2 each, ¼-20x1/2” socket flat head
machine screws. Use the cold chisel in the cement seams and a ball peen
hammer to loosen.
STEP 9:
Remove the damper handle rod from its drilling in the left stove end and
the forward drilling in the damper actuator link to fall between the left
stove end and the left air/wear plate.
STEP 10:
Remove the upper fireback and damper assembly, 4 each, ¼-20 x 1” hex
head cap screws and 4 each, ¼” flat washers. Do not allow the damper
actuator link to fall into the opening between the wear plate and the stove
end.
