6. Insert the new chain by using the plastic
chain insertion tool.
6.1 Attach the chain to the chain insertion
tool.
6.2 Place the chain insertion tool to the
chain output on the load side of the
chain fall.
6.3 Feed the chain insertion tool into the
chain guide.
NOTE
Insert the chain insertion tool into
the chain hoist and guide it through
the chain guide in the correct
position. The tip of the chain
insertion tool should point towards
the chain sprocket (towards the
back of the chain hoist). Feeding
the chain insertion tool into the
chain guide in an incorrect position
can damage the chain sprocket.
6.4 Drive the motor in the direction UP so
that it pulls the chain inside the chain
hoist.
7. Reassemble the hook block.
7.1 Insert the rubber plate or the magnetic
limit switch activator (2) on the new
chain on the hook end of the chain.
7.2 Insert the rubber cover of the hook
block (1) on the chain.
7.3 Insert the pin (5) through the first chain
link of the chain.
7.4 Attach the pin into one of the hook
block halves (3).
7.5 Assemble the hook block.
7.6 Secure the fixation with the two screws
(4).
1
5
4
2
3
7 MAINTENANCE
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
6/2020
