13. Lead the brake cables through the hoist
frame. Pull the brake cables carefully out
on the motor side.
14. Plug in the brake cables (1) and (2).
1. Main brake
2. Secondary brake
15. Push in the control board.
16. Install the end cover on both the motor side and brake side.
For more information, see chapter Removing and installing the hoist covers.
17. Tighten the screws of the end covers to the correct tightening torque.
For more information, see chapter Tightening torques for the chain hoist.
18. Turn on the power to the chain hoist.
19. Check that the brake works normally.
1.
First test the brake without any load.
2.
Then test the brake with a dynamic test load of 110% (EUR) or 125% (US) of the rated
capacity. Size of the dynamic test load depends on the country regulations.
3.
In the European countries, test the brake also with a static test load of 125% of the
rated capacity.
OWNER’S MANUAL
This document and the information contained herein, is the exclusive property of Verlinde S.A.S and represents a non-
public, confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, altered or
otherwise employed in any manner whatsoever without the express written consent of Verlinde S.A.S. Copyright 2020
© Verlinde S.A.S. All rights reserved.
6/2020
