Verint Video Intelligence Solutions
47
Nextiva S2750e Series User Guide
The following power-up conditions on the system status LED are abnormal:
Using the Command Line Interface
You may need to access the command line interface (CLI) of an edge device to perform
troubleshooting tasks, typically with the assistance of a Verint customer service specialist.
The available troubleshooting tasks include configuring quality of service (QoS).
Accessing the CLI
SConfigurator provides a network access to the CLI through the Telnet utility.
To enter the CLI with Telnet:
1. Open SConfigurator.
2. Click the Units tab.
3. Click Discover.
Condition
Description
LED not lit when the LAN
and Status LED State
parameter is On (see
page 38)
Check the power supply and cabling. If power is available and
the LED stays off, call customer service for assistance.
Steady red LED persisting
more than 10 seconds
There is an internal error that prevents the device from
starting normally. Power down the device, wait 30 seconds,
then power it up. If the condition persists, call customer
service.
Note: Ensure that your computer and the S2750e device are in the same IP subnet.
