VENT
125 Baja + Baja RR /
VENT
125 De Derapage RR
49
5
A
1
2
3
4
6
use and maintenance manual
- To access the fuses, remove the front left
conveyor, as described in its relative par-
agraph.
- Turn the start switch key to “
OFF
”.
- Remove the lid (A) from the fuse box.
Fuse position
- fuse (1)
7.5 A
: Cooling fan for the cooling
fluid radiator;
- fuse (2)
5A
: Switch for the front stop light,
switch for the rear stop light, dashboard,
control unit, intermittence of blinkers;
- fuse (3)
5A
: Front lights, back lights, light
switch, buzzer;
- fuse (4)
15A
: Start button (and starter),
light relays, clutch relay;
- fuse (5)
15A
: Contactor (and conse-
quently starter).
- fuse (6)
15A
: Spare fuse.
After checking or replacing:
- Replace the fuse in its own seat.
- Correctly replace the components re-
moved to access the fuses.
For a quick check of the proper orientation
of the front headlight:
- Place the vehicle on a solid, flat terrain.
- Leave the vehicle 10 metres away from a
vertical wall.
- Climb on to the vehicle, to the pilot posi-
tion.
- Turn the start switch key to “ON”.
- Make sure the headlight switch is in the
low beam position “
”
- Make sure the light beam projected on
the wall is slightly below the horizontal
line of the projector (about 9/10 of the to-
tal height).
- If necessary, adjust it.
Also check:
- That the light beam is uniform;
- That no shadow areas are present.
Light beam
DANGER
Incorrectly adjusted beams may cause
accidents, including serious ones.
NOTE: Based on the laws in force in the
country where the vehicle is used, checks
on the orientation of the light beams require
specific procedures.
This is the Italian procedure.
