VENT
125 Baja + Baja RR /
VENT
125 De Derapage RR
30
2
1
4
3
use and maintenance manual
Removing the wheels
WARNING
An inexperienced user may find it dif
-
ficult and complex to disassemble and
reassemble the front wheel.
In case of need, contact a VENT Dealer.
If you do wish to do it yourself, follow
these instructions.
NOTE: When disassembling and reassem-
bling the wheel, be careful not to damage
the brake tubes, disk and linings.
To disassemble and reassemble, wear
work gloves that ensure suitable protection
for fingers and hands.
Disassembling the front wheel
- Park the vehicle on the central support
kickstand, with the front wheel off the
ground.
- Have someone hold the vehicle by keep-
ing the handlebar in its driving position.
- A second operator can now loosen the
screw (1) that blocks the wheel pin and
unscrew the pin (2).
- Hold the front wheel and manually slide
out the wheel pin (2).
WARNING
Mark the spacers and keep them apart
so as not to invert their positions when
reassembling the wheel.
NOTE:
Remove the wheel, carefully sliding
the disk from the brake fork.
Remove the wheel by sliding it forward.
WARNING
Do not activate the front brake after
removing the wheel, otherwise the
fork pistons can leave their seats and
cause braking fluid to leak.
If this happens, contact a VENT Deal-
er.
Reassembling the front wheel
- Have someone hold the vehicle by
keeping the handlebar in its driving po-
sition.
- Moderately grease the outer seats of
the wheel hub.
- A second operator should position the
wheel beneath the parts of the fork, in-
serting the brake disk into the fork.
- Use grease on the wheel pin and slide
it completely with the spacer (3) into
the wheel hub (left side) and the spac-
er (4) (right side).
- Tighten the wheel pin (2).
Wheel pin torque: 80 Nm (8 kg/m).
- Remove the central kickstand.
- With the front brake lever activated,
press repeatedly on to the handlebar,
causing the swingarm to dip.
This will allow the swingarm parts to
settle appropriately.
- Park the vehicle on its kickstand.
- Tighten the screws (1) of the wheel pin
clamp (right side).
Wheel pin clamp screw torque: 10 Nm
(1.0 kgm).
DANGER
After reassembling, repeatedly acti-
vate the front brake lever and make
sure the braking system is functioning
properly.
