VENT
125 Baja + Baja RR /
VENT
125 De Derapage RR
45
A
1
2
4
3
use and maintenance manual
Clutch command lever
The lever is ergonomically positioned dur-
ing vehicle assembly.
Adjusting the position
The position of the clutch lever on the han-
dlebar can be adjusted downwards or up-
wards by loosening the fixating screws (1).
On reaching the desired tension, tighten the
screws (1).
Clutch regulation
Adjust the clutch if:
- When the clutch lever is activated and a
gear is inserted, the vehicle moves for-
wards (the clutch does not detach);
- During acceleration, the engine improp-
erly increases the rotations per minute
and there is a delay in the transferring
of motion to the rear wheel (the clutch is
jammed and, as a consequence, skids).
Proceed as follows to adjust:
- Park the vehicle on its kickstand.
- Move away the protection casing (2).
- Loosen the ferrule (3).
- Rotate the grub screw (4) until the empty
strike (A) of the clutch lever, controlled at
the tip of the lever, is about
3-4 mm
.
- Keep the grub screw in position (4) and
tighten the ferrule (3), locking the grub
screw (4).
- Replace the protection casing (2).
Checking for proper regulation
- Start the engine.
- Completely activate the clutch lever, in-
sert the first gear and make sure when
the clutch lever is released, the vehicle
moves fluidly, without presenting any of
the defects described above.
WARNING
If it is not possible to obtain proper
clutch regulation or if the clutch is work-
ing irregularly, contact a VENT Dealer.
NOTE: Check the integrity of the clutch ca-
ble all over its length. The sheath must not
present fissures, cuts, squashed points or
signs of wear. If even one of these defects
is identified, have the clutch cable replaced
by a VENT dealer.
- Periodically lubricate the clutch cable
with a suitable lubricant.
