EN
-36-
The operation of the device can be
monitored via the instant power indicator
on the LCD screen. The device
automatically adjusts the amount of
energy needed according to the desired
outlet water temperature and the amount
of energy consumed during this time
(between 10% and 100%) can be
monitored from the LCD screen of the
device. The "eco" indicator located just below the instant power indicator
remains on when the amount of energy spent is below 60%. The "eco"
indicator indicates that the device performs the heating operation
economically according to the amount of energy that it spends instantly.
The "eco" indicator goes off at instantaneous power values of 60% and
above, indicating that the device is heating up with more energy. To use the
device economically, make sure that the desired water temperature and
water volume are not exceeded.
The water temperature displayed on the screen indicates the temperature
sensed inside the device. The water temperature from the utility taps varies
due to the heat losses in the piping in the installation and may be lower than
desired.
Use with Solar Energy Systems
The BLUE S three-phase electronic flash heater can be operated with
preheated water as well as in solar power
systems. If the inlet water temperature of
the device exceeds 30 ° C, the sun
symbol on the LCD screen will light up.
This means that the device is preheated
water inlet and that the device is
consuming enough energy to reach the
desired temperature value. The point to
note when using solar energy systems is
that the inlet water temperature does not exceed 55 ° C.
