EN
-28-
Prepare the cold water line and hot water line connections of the closed
loop installation for the device to be installed. If so, remove the blind plugs
from the connectors. Before connecting the water mains to the water inlet
of the device, clean foreign matter from the system. This can be done by
draining the water for a while after connecting a hose to the water main.
Teflon tape or the like on the long side of the water inlet tap and water
outlet recorder supplied with the device and seal the sealant.
As shown in the figure on the right, connect
the water inlet tap to the cold water side and
the water outlet record to the hot water side.
Check the directions of the connections. The
arrows on the record and the tap must be in
the direction of the water flow!
Place the device in the wall as shown above, mark the screw holes, drill
and insert the anchors. You can use any of the openings shown in the
figures above for the connection cable by breaking it from the marked
points if necessary. Screw the device into the wall after taking the cable to
the side of the terminal.
