Multi-Format STB Quick Start
9
Chapter 2
Configuration
Topics in this chapter
Displaying the Setup Page . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
STB Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Upgrade, Reset, Change Password . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Displaying the Setup Page
The Setup pages are used to set various configuration options such as IP Address and Start
Mode. As shown in Table 7, different setup pages are displayed depending on the password
you enter.
To launch the Setup pages:
1. Connect the STB to the display device.
2. Power the STB off and on with the red power button on the remote control.
3. Wait until the VBrick logo is replaced by a black screen.
4. When the animated "Starting" circle is displayed, start pressing the
Help (?)
button on the
remote and continue until the Password page is displayed.
5. Enter the password corresponding to the pages you wish to edit.
Table 7.
Setup Program Passwords
Changing the IP Address
By default, the set top box is configured for DHCP (Dynamic Host Configuration Protocol)
and will automatically retrieve an IP address from a DHCP server if present. If a DHCP
server is not present or unavailable, you can configure the set top box with a static IP address
and other network options. If you have the VBDirectory management program installed you
easily find any networked VBrick devices. See VBDirectory on page 30 for more information.
To find the IP address launch the Setup program as explained below or in Local Mode use
the remote control (use the unlabeled third button down on the right). Then move the cursor
to the Information icon in the lower left area of any page and click on the Info icon This will
display the IP Address, MAC Address, Firmware Version, and other data (see Figure 8). The
set top box is configured for DHCP by default and will automatically acquire an IP address
when plugged in if your network is DHCP-enabled.
Password
Use To ...
1234
Set IP Address, Start Mode, Video & Audio Output Setting, etc.
5678
Upgrade, Reset Factory Defaults, change Password.