Vauxhall 2007 Vectra, Operating & Safety Manual

Page: 82 / 324

78 Keys, doors, bonnet
Basic programming of the universal radio
control system
1. Switch on ignition.
2. When programming for the first time,
press both outer buttons under the
mirror housing, until the control indicator
alongside the buttons flashes rapidly.
3. Hold the manual remote control unit at a
distance of 0 to 30 cm from the control
button area of the mirror housing.
4. Press the button on the manual remote
control unit while pressing and holding
the desired button of the universal radio
remote control.
5. The control indicator in the mirror
housing will flash slowly at first. As soon
as it flashes rapidly, release both
buttons. The universal radio control
system is now programmed for the
chosen system.
6. To program other buttons with other
systems, repeat steps 3 to 5.
If a system cannot be operated after
repeated programming, and the control
indicator flashes rapidly for a short time
after the relevant button has been pressed
and then illuminates for 2 seconds, the
receiver may be equipped with a variable
code system, see next page.
Programming the universal radio control
system for variable code systems
1. Perform basic programming
– see previous column.
2. Activate synchronisation mode of
system (see system manufacturer’s
system operating manual) and briefly
press the pre-programmed button on
the universal radio remote control three
times within 30 seconds.
3. The radio control system is now
programmed for variable code systems.
To program other systems for variable
codes, repeat steps 1 and 2 for the other
buttons of the universal radio remote
control system.
Ofrecido por www.electromanuales.com