3
C
onStruCtIon
of
the
mIxer
:
Bowl clamping system
with inductive sensor:
At the back of the right-
hand bowl arm is an in-
ductive sensor which is
activated when the bowl
is correctly positioned in
the bowl clamping system
(at the very back of the
bowl arms). This sensor
must be activated in order
for the mixer to operate.
If there is no contact be-
tween the bowl and the
inductive sensor, the bowl
cannot be lifted.
will appear in the display,
see “Error codes shown in
display” on page 10.
The bowl arms can move
a little in case of maximum
loading.
Safety guard –
removable.
The guard must be
closed before the tool
can rotate.
The bowl can be raised
with the guard open,
but it will stop where the
tool normally starts to
rotate. The guard must
be closed and two hands
are required to lift the
bowl the rest of the way.
VL-4 control panel with
Remix function
See page 5 for an explana-
tion of the panel.
Emergency
stop
Magnetic sensor, which
is activated by the guard
when the guard is closed.
Bowl lift and “JOG”-func-
tion:
The mixer is provided with a
“JOG”-function.
Before the bowl reaches its
top position, the tool starts
rotating to dig its way into the
ingredients.
The bowl lift requires two-
hands operation for safety
reasons.
P
oSItIonInG
the
bowl
In
the
mIxer
:
The bowl arms must be lowered to their lowest position and the bowl pressed all the way to the back of the bowl arms. If
there is no contact between the bowl and the inductive sensor, the bowl cannot be lifted.
will appear in the display,
see “Error codes shown in display” on page 10.
If you have a bowl with “ears” it is important to place it correct in the mixer.
Note: It is very important to orientate the bowl correctly
so that the “third ear” is turned in towards the mixer
Left “ear”
Right “ear”
Third
“ear”
Summary of Contents for ERGO100
Page 14: ...14 Electrical components...
Page 15: ...15 Safety circuit...
