22
Relubricating of lifting actuator spindle on ERGO 60-100-140
Page 2
Mar
king of lo
wer
Reed swi
tch
(proxi
mity
sensor)
60L
•
Three Reed switches are fitted to the spindle tube. The bottom switch must be loosened
before the spindle tube can be moved.
•
Mark with a dark marker pen around the switch and clip, so that the switch can be fitted
in exactly the same place after lubrication.
•
Push the switch approx. 50 mm upwards, so that it is free of the machine’s lower bed
Mark pins
Release cables
to the Reed
switches on
the actuator.
60L-100L-140L
•
Mark the three pins going to the three Reed switches on the actuator
•
Remove the pins.
•
Cut the various cable ties securing these cables.
•
Then be careful not to damage cables that are hanging loose.
Loosen the
pointed screw
and unscrew
the outer
tube from the
gear
60L-100L-140L
•
Loosen the pointed screw located at the side of the gear.
•
Hold the outer tube and screw clockwise until it is free of the gearbox
•
Lower the tube so it is resting on the bowl arms
Summary of Contents for ERGO100
Page 14: ...14 Electrical components...
Page 15: ...15 Safety circuit...
