VAN DER ENDE Vacon 100 Flow, Manual

Page: 25 / 40

Vacon 100 Flow
page
25
The application wizard is launched during first startup, or via parameter (P1.2).
At startup, the date and time must be filled in correctly. You are then asked if you want to
open the application wizard.
Then you are asked about what application is being used:
 Standard Continue to Section 6.2.1
 HVAC
 PID - control Continue with Section 6.2.2
 Multi-pump (single drive)
 Multi-pump (multi-drive) Continue to Chapter 8
6.2.1 Default Application (Wizard)
Be careful! The factory setting must always be used as a starting point when using the
application examples in this book. (P6.5.1)
After choosing default, the following parameters appear:
Step Parameter Number Description
1 Motor type P3.1.2.2 Permanent magnet or induction motor
2 Rated voltage P3.1.1.1 Varies
3 Rated frequency P3.1.1.2 8 to 320 Hz.
4 Rated motor speed P3.1.1.3 24 to 19,200 rpm
5 Rated motor current P3.1.1.4 Varies
6 Cos phi of the motor P3.1.1.5 0.3 to 1
7 Minimum frequency P3.3.1.1 0 Hz. … P3.3.1.2
8 Maximum frequency P3.3.1.2 P3.3.1.1 … 320 Hz.
9 Acceleration time P3.4.1.2 0.1 to 300 s
10 Deceleration P3.4.1.3 0.1 to 300 s
11 Operating location: I/O - terminals
Fieldbus
Control panel
12 Logic I/O A P3.2.6 Forward-reverse If reset error, autostart
Forward-reverse (pulse) If reset error, break start contact