VAMP 130
Overcurrent and earth-fault relay
Operation and Configuration
VAMP Ltd
20
Vamp 24h support phone : +358 (0)40 573 6316
VM130.EN003
5.6.
Configuring blocking matrix
BLOCKING
Configuration of the blockings is done under the BLOCKING
menu. Any start or trip signal can be used to block the operation
of any wanted protection stage.
5.7.
Disturbance recorder menu
RECORDER
Via the disturbance recorder menu the following functions can
be read and set:
•
Recording mode (Mode)
•
Sample rate (Rate)
•
Recording time (Time)
•
Pre trig time (PreTrig)
•
Scroll list of active links (Links)
•
Add a link to the recorder (AddLink)
•
Clear all links (ClrLink)
•
Manual trigger (MnlTrig)
•
Count of ready records (ReadyRec)
For list on available links see chapter 2.6 in the technical
description.
5.8.
Configuring digital input DIGITAL IN
Via the submenus of the DIGITAL IN menu the following
functions can be read and set:
•
Status of the digital input (DI1)
•
Operation delay (D1 dly)
•
Polarity of the input signal (DI1pol), either normally open
(NO) or normally closed (NC) circuit.
•
Remote release of latches using digital input (RemRel)
•
Selection to event register (OnEvent and OffEvent)
5.9.
Service menu SERVICE
Via the submenus of the Service menu the following functions
can be read and set:
