Valtra 600, Operator'S Manual

Page: 132 / 142

---131--- K. Extra equipment
2.2.
Connecting to the jaw
Mechanical jaw
69--- 122
2
3
For lifting up the drawbar pin pull up the ring ( 3 ) at the top
of the coupling lever ( 2 ).
WARNING: After coupling the trailer, check
that the pulling pin is completely down and
locked.
NOTE: When using jaws, where the towing pin is equip-
ped with locking pin, make sure, when coupling the trai-
ler, the locking pin is locked.
Automatic jaw
69--- 122,2
4
5
For connecting the trailer to the coupling, lift the puller up
by turning lever (
4 ) to the upper position. When the draw
eye reaches the bottom of the draw gap, the coupling
automatically goes down. The towing pin can also be
lowered by pushing lever (
5 ) downwards.
69--- 123
WARNING: The drawbar pin is locked in the
down position when the security knob is
out. When coupling the trailer the drawbar
locking pin must be secured.
69--- 124
To ensure the allowed pulling angles drawbar eyes with
pulling pins of 30 --- 38 mm must only DIN 74054/11026
be used. A solid drawbar must be used because of the
clearance in the jaws.
NOTE: Use only drawbar eyes which comply with the
regulations and are undamaged. When using other
than the allowed drawbar eyes the guarantee/warranty
lapses and responsibility becomes invalid.
CAUTION: When using the hydraulic hitch with the
wagon towing device, take care that the link of the
trailer does not touch the drawbar body.
3.
Maintenance and greasing
Maintenance of the mechanical and automatic jaws are
alike.
69--- 102,2
1
2
3
4
5
3.1.
Clean regularly:
--- the main pin ( 1 ) (no pressure wash)
--- the control unit of the puller pin ( 2 )
--- the locking pin ( 3 ) (2 pcs)
NOT LOCKED
PULLING PIN
LOCKED