---38---
D. Instruments and controls
Speed under 4 km/h, lower curve, adjusting
screw (1)
--- By rotating the adjusting knob (
1
) in the closed direction
(clockwise) (the lock nut has to be slackened
A
), the
clutch rises slower (the curve is gentler) and vice versa.
The factory set adjustment is 1 and a
1
/
4
turns open.
NOTE: The clutch pedal rising speed can not be
adjusted too slow, in order that the clutch does not
slip and wear unnecessarily. The minimum value is
open 1 turn, because of clutch slip. Always adjust
Knob 1 first.
Speed over 4 km/h the upper curve, adjusting
screw (2)
--- By rotating the adjusting knob (
2
) in the closed direction
(clockwise) (the lock nut has to be slackened
A
), the
clutch rises slowly (the curve is gentler) and vice versa.
The factory set adjustment is 2 turns.
D 2.3.1.5.
Differential lock (1
.5
)
69--- 27,4
1
.5
Engaging:
Push down the lever.
Disengaging:
Reduce the engine speed and pull the lever
up.
CAUTION: The differential lock can be engaged while
running straight ahead without wheel slip.
D 2.3.2.
Rear linkage (mechanically
controlled hydraulic lift) (2)
D 2.3.2.1.
Position control lever (2
.1
)
2
.1
2
.2
69--- 27,5
Front position:
Lifting arms lowered.
Rear position:
Lifting arms raised.
D 2.3.2.2.
Locking device of position control le-
ver (2
.2
)
The movable lever stop (
2.2
), marks the position of the
lever. It facilitates return to its previously set position after
a lifting operation or similar.
CAUTION: The lever should be locked in the rear
position with the stop when the hydraulic lift is not
being used or if there is a heavy load on the
three ---point mounting (further instructions on
page 55).
D 2.3.2.3.
Lowering speed control (2
.3
)
2
.3
69--- 27,2
The lowering speed control adjusts the lowering speed of
the lower links.
Rear position = Max. lowering speed
Front position = Min. lowering speed
CAUTION: Minimum lowering speed should always be
used when heavy implements are mounted on the
hydraulic lift.
D 2.3.3.
Rear power take ---off (3)
D 2.3.3.1.
Selector lever, power take---off (3
.1
)
3
.1
69--- 27,3
The tractor has some of the following PTO speed
Summary of Contents for 600
