---73---
H. Periodic maintenance
H 4.2.4.
Filling
Oil quality is to be in accordance with the table on
page 63.
Fill up with new oil to the prescribed level (upper mark on
dipstick
3
) through the filler opening (
2
).
Oil volume
incl. filter
---600, 700
7 l
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
---800, 900
9 l
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Filter capacity
0.5 I
.
The distance between max and min marks on the dipstick
corresponds to
1.5 liters
of oil.
Then start the engine in the normal way. Allow the engine
to idle for a little while and check the oil level again.
H 4.3.
Lubricate gear lever joints (12)
65--- 70
Carefully clean joint before lubricating. Lubricate the joint
with Valtra Grease Moly. Carry out lubrication every 250
hours or when necessary.
H 4.4.
Check tyre/tire pressures and
wheel nuts (13)
NOTE: Check tyre/tire pressures and torque of wheel
nuts (also rim/wheel discs) frequently (values are
listed in the Technical Specifications on page 98).
WARNING: Avoid over inflation as excess
pressure may cause the tyre/tire to explode
.
It is recommended that the changing of tyres/tires and
wheels is carried out in a professional tyre/tire workshop
which is equiped to handle this type of work.
DANGER!
When welding the discs the tyre/tire must be
away from the rim/ disc, DANGER OF
EXPLOSION!
When mounting the tyre/tire on the disc the pressure limit
is 250 kPa. If the tyre/tire does not go on the disc properly,
remove it and refit. When the tyre/tire is positioned
correctly on the disc, inflate to correct pressure.
H 4.5.
Check brake fluid level (14)
69--- 69,1
The fluid level should be between the max. and min.
marks. Top up with new fluid as necessary, see recom-
mended fuel and lubricants on page 63.
WARNING! Normally there will be no need to
top up the fluid. If leakage has occurred, it
must be repaired immediately, before dri-
ving. If necessary, contact the authorized
Valtra ---workshop.
The brake fluid level should be checked frequently. Use
recommended fluid only.
65--- 70,2
If the tractor is equipped with the push buttons for HiShift
as extra equipment, check the brake fluid level. The brake
fluid reservoir for HiShift is to the left side of the battery.
Check, that the fluid level is between the min. and max.
marks.
Summary of Contents for 600
