Valtra 600, Operator'S Manual

Page: 78 / 142

---77--- H. Periodic maintenance
--- Subsequent to refilling, the engine should be started
and the hydraulic lift operated for a short time, after
which the level should be checked again. Replace the
breather filter (
2 ) and adjust it with fastening tube ( 3 ) so
that the filter top is horizontal.
Where the larger quantity is recommended, 35 l, the oil
level should come up to the upper mark on the
dipstick which is fitted on the oil filler cap. Then 24 l
can be taken out for auxiliary hydraulics.
H 6.2.
Change oil in power
transmission (26)
Draining
A3565--- 112,1
--- Run the tractor to warm up the transmission oil.
--- Remove the plugs under the gearbox and final drive
gears and allow the oil to run out into a suitable
container.
--- Clean the plugs and screw them in again.
Filling
65--- 75
Oil quality should be in accordance with the table on
page 63.
--- Remove the plug on the dipstick opening
--- Fill up with new oil to the upper mark on the dipstick.
Oil quantity is 32 l. The distance between max and min
marks on the dipstick corresponds to 3 liters of oil.
H 6.3.
Change oil in differential
(powered
front axle)
(27)
A3565--- 114
2
1
3
Remove the drain plug ( 1 ). Clean the plug and screw it in
again. Fill up with new oil to the lower edge of the level
plug (
2 ).
Oil volume 6.5 l
Oil quality should be in accordance with the table on
page 63.
H 6.4.
Change oil in hub reduction gears
(powered front axle)
(28)
A3565--- 108
Unscrew the plug and drain the oil. Turn the wheel until
the line of the inspection hole is horizontal and fill up with
oil to the level of the hole.
Oil volume 2 x 0.8 l
Oil quality should be in accordance with the table on
page 63.