---118---
K. Extra equipment
K 2.3.2.
HiShift for the rear PTO switch
1.
Instructions for operating
69--- 130
1
2
3
The rear PTO HiShift switch (
1
) is situated on the right
side panel or side pillar, depending on the equipment.
With the HiShift switch (
1
) of the rear PTO, the PTO can be
switched on and off without using the PTO (
2
) clutch lever.
The disengagement with the clutch lever (
2
) is always
possible.
NOTE: With the HiShift switch (1) or the lever the PTO
can be disengaged only temporarily (max. 5 min.).
When the PTO has been disengaged with this lever the
indicator light the instrument panel lights up on.
The switch is a three position switch:
---
When the opposite side to the symbols is pressed
down = OFF
, PTO disconnected
---
In the centre position
=
ON
, PTO connected (fast en-
gagement)
---
When the symbols side is pressed down
, spring loa-
ded =
slow engagement
of the PTO
The engagement and disengagement of the PTO will be
done the same way, when using the HiShift (
1
) or the
clutch lever (
2
).
1.1.
Engagement
--- Adjust the engine speed to low idling
--- Press the opposite side to the symbols of the HiShift (
1
)
down to disconnect the clutch disc = OFF---position,
the light on the instrumentpanel is on
--- Move the PTO selector lever (
3
) to the desired PTO ran-
ge speed position
Fast engagement
--- If the rotating material/mass of the implement engaged
with the PTO, is small, the PTO will be engaged by pres-
sing the HiShift (
1
) in the middle position (ON). In that
case the PTO starts to rotate quickly.
Slow engagement
--- If the load is greater, press the symbol side of the HiShift
(
1
) down and hold until the PTO is totally connected.
After that the switch will be released.
1.2.
Disengagement
Adjust the engine speed to low idling
--- Press the opposite side of the symbols of the HiShift (
1
)
down to detach the clutch disc = OFF---position, the
light on the instrument panel is on.
--- Move the PTO selector lever (
3
) to the middle position
= the PTO range speed is off.
--- Press the PTO HiShift switch (
1
) to the middle position
NOTE: The PTO HiShift switch (1) must always be in mid-
dle position (= the light on the instrument panel is off),
if the PTO is not in use.
For more details on using the PTO see the Working in-
structions beginning (in section
F
) on page 52.
Summary of Contents for 600
